Sherbourn PRE-1 Instrukcja Naprawy Pobierz pdf (Strona 9)

Rear Panel Layout

1. TRIGGER OUTPUT

Allows a mono to mono 3.5mm cable to remotely trigger

another device on and off, along with the PRE-1. Current

is limited to 500mA, which is sufficient to trigger two

devices. For triggering more devices, you may want to use

a separate triggering device, like the Sherbourn ET-3.

2. PHONO INPUT Section (clockwise from top left)

• Phono Ground

• Left and Right channel RCA inputs

• MC/MM Switch. Use this switch to select your cart-

ridge type. MC for Moving Coil or MM for Moving

Magnet.

3. AUDIO Section (from left to right)

• CD Player inputs (Switchable Balanced or Unbal-

anced)

• Tuner inputs

• Auxiliary 1 inputs - Suitable to connect to any audio

device with Left and Right analog outputs.

• Auxiliary 2 inputs - Suitable to connect to any audio

device with Left and Right analog outputs.

4. TAPE INPUT/OUTPUT

A tape loop is provided for recording 2-channel source

material from a Cassette, DAT or a Hard Disk Audio

device with analog outputs.

5. HT INPUT (Home Theater) Switchable Balanced or

Unbalanced

Allows the PRE-1 to connect to an external

multichannel/home theater processor. This connection is

disengaged when the PRE-1 is in normal mode, but be-

comes active when the HT BYPASS button is selected

on either the PRE-1 front panel or remote control. In HT

BYPASS mode, this connection becomes active and the

PRE-1 becomes a pass-through . This is a true 'straight

wire' pass-through - what

comes in is what goes out.

NOTE: HT INPUTS are only active when the PRE-1 is

on. ALL PRE-1 functions become disabled in HT BYPASS

mode, allowing the external processor to control volume,

EQ, etc.

AUDIO OUTPUT SECTION

6. Balanced Output

Balanced (XLR) connection for left and right speakers.

7. RCA Outputs

Standard RCA connections for left and right speakers.

8. Main Power Switch

This rocker switch provides the master power for the PRE-1.

After it is in the ON position, the PRE-1 can be turned on

manually from the front panel switch, remote control, or

automatically with the trigger input via a

3.5mm input jack.

9. Power Receptacle Uses standard IEC power cord.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Komentarze do niniejszej Instrukcji

Brak uwag

Sherbourn PRE-1 Instrukcja Naprawy Strona 9

Komentarze do niniejszej Instrukcji